UV induced surface modification on improving the cytocompatibility of metallocene polyethylene

ABSTRACT Demand for medical implants is rising day by day as the world becomes the place for more diseased and older people. Accordingly, in this research, metallocene polyethylene (mPE), a commonly used polymer was treated with UV rays for improving its biocompatibility. Scanning electron microscopy (SEM) images confirmed the formation of crests and troughs, which depicts the improvement of surface roughness of mPE substrates caused by UV etching. Accordingly, the contact angle measurements revealed that the wettability of mPE-2.5 J/cm2 (68.09º) and mPE-5 J/cm2 (57.93º) samples were found to be increased compared to untreated mPE (86.84º) indicating better hydrophilicity. Further, the UV treated surface exhibited enhanced blood compatibility as determined in APTT (untreated mPE- 55.3 ± 2.5 s, mPE-2.5 J/cm2 - 76.7 ± 4.1 s and mPE-5 J/cm2 - 112.3 ± 2 s) and PT (untreated mPE - 24.7 ± 1.5 s, mPE- 2.5 J/cm2 - 34.3 ± 1.1 s and mPE-5 J/cm2 - 43 ± 2 s) assay. Moreover, the treated mPE-2.5 J/cm2 (4.88%) and mPE-5 J/cm2 (1.79%) showed decreased hemolytic percentage compared to untreated mPE (15.40%) indicating better safety to red blood cells. Interestingly, the changes in physicochemical properties of mPE are directly proportional to the dosage of the UV rays. UV modified mPE surfaces were found to be more compatible as identified through MTT assay, photomicrograph and SEM images of the seeded 3T3 cell population. Hence UV-modified surface of mPE may be successfully exploited for medical implants.

Pullulan as a stabilizer agent of polymeric nanocapsules for drug delivery

ABSTRACT Polymeric stabilizers have received attention in the preparation of nanostructured systems due to their ability to enhance formulation stability. Considering this, the objective of this work was to prepare poly(ε-caprolactone) nanocapsules using the pullulan as a polymeric stabilizer. The nanocapsules were prepared using the interfacial deposition method of preformed polymers and they were characterized in terms of pH, average diameter, polydispersity index, zeta potential, beclomethasone dipropionate content, encapsulation efficiency, photostability and drug release profiles. The formulations showed physicochemical characteristics consistent with nanocarriers for drug delivery such as: average diameter lower than 270 nm, polydispersity indexes lower than 0.2, negative zeta potential (-22.7 to -26.3 mV) and encapsulation efficiencies close to 100%. In addition, the nanocapsules were able to delay the beclomethasone dipropionate photodegradation under UVC radiation and by the dialysis bag diffusion technique, the nanocapsules were able to prolong the drug release. Thus, pullulan could be considered an interesting excipient to formulate polymeric nanocapsules.